Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the wash cycle 2. Warning! The company shall not be held responsible in the event that these regulations are not respected.The power supply cable must only be replaced by authorized technicians.The cable should not be bent or compressed.Do not use extension cords or multiple sockets.When the washing machine has been installed, the electricity socket must be within say reach.It is extremely dangerous to leave the appliance exposed to rain, storms, and other weather conditions. The washing machine must not be installed outdoors, even in covered areas.If this is not the case, replace the socket or the plug. the socket is compatible with the plug of the washing machine.the power supply voltage falls within the values indicated in the Technical data table (see opposite).the socket is able to withstand the maximum power load of the appliance as indicated in the Technical data table(see opposite).the socket is earthed and complies with all applicable laws.We advise against the use of hose extensions if it is absolutely necessary, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.īefore plugging the appliance into the electricity socket, make sure that: The free end of the hose should not be underwater. Use the ones supplied with the machine.Ĭonnect the drain hose, without bending it, to a drainage cut or wall drain located at a height between 65 and 100 cm from the floor Īlternatively, rest it on the side of a washbasin or bathtub, fastening the duct supplied to the tap (see figure).If the inlet hose is not long enough, contact a specialized shop or an authorized technician.The water pressure at the tap must fall within the values indicated in the Technical details table (see next page).Make sure that the hose is not folded over or bent.The top right-hand side of the rear part of the appliance (see figure). Connect the inlet hose to the washing machine by screwing it onto the corresponding water inlet of the appliance, which is situated on.Connect the supply pipe by screwing it to a cold water tab using a ¾ gas-threaded connection (see figure).īefore performing the connection, allow the water to run freely until it is perfectly clear.

Hotpoint 24 gas range manual